Saxophone Post Raising Tool

Product Information

FN60, FN60B, FN60A SAX POST RAISING TOOL

If a saxophone post or pillar has been pushed into the body, causing binding keywork and dents, it can be pulled back into position with the F-N60 tool. It is double ended to fit all common sized posts, and the N60B will fit Baritone saxes. You will required the L13 slide removing tool or some kind of similar puller. Simply place the tool over the affected pillar (you do not need to remove the springs) and hook your pulling tool through the hole at the other end. Aligning the puller to the correct angle, a few light pulls is usually enough to correct the damage. This method can also be used to pull dents from large brass, by soldering a temporary pillar into the centre of the dent, and using the same technique.